AXOBOX ASSEMBLY GUIDE

On this page you’ll find all the necessary instructions to assembly your AXOBOX with Axoloti and Axoctrl.

Knowledge of electronic is not required for this product.

 

Required tools

  

List of components

In the package you’ll find all the components needed to assembly your AXOBOX: 

  • 6 x M3 screws
  • 4 x M3 HEX turrets
  • magic Hohum tool

Instructions

1) Get all the parts out of the package and start placing your AXOBOX on a desk.

DSC_0001-min
2) Take your Axoloti and slide it in position inside the box.

3) Push slightly the USB host port from the backside through the plastic space till you hear a “click”.

DSC_0025-min

4) Use the two short M3 screws to complete the attachment of your Axoloti. You will need a cross-head screwdriver to do this step. Do not tighten the screws too much.

DSC_0016-min
DSC_0022-min
5) Screw the plastic nuts on the jack port from the backside panel.

DSC_0023-min
If you have the plain faceplate
6) Place the HEX turrets in the 4 corners of the box. Use the Magic tool to help yourself in this step. Do not tighten the turrets too much, just till they reach the end point.

7) Place the faceplate in position and use the 4 screws to complete the assembly. You’ll need a cross-head screwdriver to do this step.

DSC_0034-min
DSC_0039-min
If you have the Axoctrl
8) Attach the Axoctrl shield on top of Axoloti Core. Make sure you’re aligned with the shield slot and supports.

DSC_0275-min
9) Place the HEX turrets in the 4 corners of the box. Use the Magic tool to help your self in this step. Do not thighten the turrets too much, just till they reach the end point.

DSC_0272-min
DSC_0268-min